#IDISPLAY MAC CLICK IP ADDRESS PORT HOW TO#

#IDISPLAY MAC CLICK IP ADDRESS PORT HOW TO#

Note: To set the CLICK Time and Date from C-more, refer to the CLICK Help file information on how to change Date/Time from an external device (how to change the Date/Time without using CLICK programming software). The amount of Time (in tenths of a second) that the C-more panel will wait in between each request. Once the Timeout timer expires, it will then retry. The amount of Time (in tenths of a second units) that the C-more panel will wait on a reply after sending a request. Once the Retry count has been reached, the Panel will show an Error on the screen and begin trying to send messages again. The number of times that the Panel will Retry to send a message if the request does not receive a Reply in the specified Timeout period. The number may need to be adjusted for specific controllers that have a limit to the number of Coils allowed in a Read or Write Message.

If fewer Coils per Message are used, this reduces the communication time for a single message and increases the amount of error checking that is done. Selects the number of Coils to be Read/Written per Message. The number may need to be adjusted for specific controllers that have a limit to the number of Registers allowed in a Read or Write Message. If fewer Registers per message are used, this reduces the communication time for a single message and increases the amount of error checking that is done. Selects the number of registers to be Read/Written per Message. This number may need to be adjusted for firewall/router purposes.

Specifies the destination TCP port number that C-more will send to the CLICK CPU. Use the CLICK Programming Software to find the IP Address for the CLICK PLC. The fields available are described in the table below. Click Yes to accept and the fields for the selected Protocol will be displayed as shown belowĪlways remember that the IP Address and PLC Port field values MUST match the field values on the CLICK Programming Software setup explained above.Any time you select a different PLC Protocol than the one already displayed, a Warning Message pops up.

Idisplay mac click ip address port